1975 Plymouth Duster Coupe 360 Base
This is a 1975 Plymouth Duster 360 cid 4-Barrel, 727 TorqueFlite
Transmission, Heavy-Duty Suspension, Power Front Disc Brakes
What I like about this car:
Everything.
What I do not like:
Nothing.
A: Can you manually close rear power window on voyager??
Yes, if you remove the door panel and loosen the motor you can pull it up and then reassembly the vehicle..
A: Why won't my 93 Colt start when it's raining??
Visually inspect the spark plug cables for burns, cuts, or breaks in the insulation. Check the spark plug boots and the nipples on the distributor cap and coil. Check for moisture inside the distributor cap as well.
Raise the front of the vehicle slightly. Remove the wheel and tire assembly. Remove the inner fender plastic splash shield retaining screws and remove the shield. Support the door assembly. Remove the door retaining pin on the hinge. Remove the hinge plate retaining bolts from inside the fender well. Remove the door assembly. Install the hinge plate in position and install the retaining bolts. Do not tighten them completely. Install the hinge pin and check the door alignment, there should be a 1 / 4 in. (6mm) gap around the sides of the door. Tighten the hinge mounting bolts. Install the inner fender splash shield, then install the wheel. Lower the vehicle.
A: did plymouth make a 1952 concord 2dr.coupe fastback?
These are the following concords that they did make in 1952.. 2 Door Business Coupe 2 Door Coupe 2 Door Sedan 2 Door Suburban Station Wagon